[HCD405RC with HRC-02 ] – DALI Sensor
20 October 2018
[HCD450VDSRC with HRC-05] – Microwave Aisle Sensor with Remote Control
21 October 2018
[HCD418] DALI Sensor Independent Version
Product Introduction
HCD418 is a 1-10V ballast/driver is being replaced by DALI ballast/driver. This sensor contains a DALI power supply circuit, which gives DALI output to the driver to carry out the sensor on/off and dimming command.
Mechanical Structure
Specifications
| Operating voltage | 120-277VAC |
| Max. Switched power | 30mA (15 devices) |
| Standby power | <1w |
| Detection area | [ 10 | 50 | 75 | 100 ]% |
| Warmming-up time | 20s |
| Hold time | 2s |30s | 1min |5min |10min | 20min | 30 min |
| Daylight threshold | 2~50Lux | Disable |
| Standby period | 0s | 10s |1min | 5min | 10min | 30min | 1H |+ infinity |
| Standby dimming level | [ 5 | 10 | 20 | 50 ]%, |
| Microwave frequency | 5.8GHz+/-75MHz |
| Microwave power | <0.2mW |
| Detection range | Max.(O x H):12m x 6m; where O is the detection angle |
| Detection angle | 30~150 Degrees |
| Mounting height | 6m |
| Operating temperature | -35~ +70 Degree Celsius |
| IP rating | IP20 | IP65 only when used with Hytronik HC-IP65 |
| Certification | Semko, CB, EMC, CE, R&TTE, SAA |
