[HIR02/SAM7 + HC038V (1-10V) , HIR02 /SAM7 + HCD038 (DALI)] – Detached linear Sensor Tri-level Dimming Control
21 October 2018
Flush Mounting Installation for Triac Dimmer
21 October 2018
Built – in Micro-sensor for T8 LED Lamp
Product Introduction
This sensor is a mini motion switch, to be built-in the T8 LED lamp to turn on the light upon detection of movement, and turn off the light after a pre-defined hold-time when there is no people around. A daylight sensor is also built-in to switch off the light when there is sufficient natural light.
The sensor picks up motion signal, switches on the power to LED; when the motion hold-time ellaped, reduces the current to LED lamp by 0~5 VDC PWM (pulse width modulation) or high-low voltage signal (0/5 VDC) to achieve on/off control, 2 steps dimming control, or 3 steps dimming control.
Specifications
| Operating voltage | 9-15V at 30mA |
| Ripple current | < 15% |
| Max. Switched power | Max.30mA (15 devices) |
| Standby power | <1w |
| Detection area | [ 10 | 50 | 75 | 100 ]% |
| Warmming-up time | 20s |
| Hold time | 5s |30s | 1min |5min |10min | 20min | 30 min |
| Daylight threshold | [ 2 | 5 | 10 | 50 | 100 | 300 | 500 Lux ] | Disable |
| Standby period | 0s | 10s |1min | 5min | 10min | 30min | 1H |+ infinity |
| Standby dimming level | [ 10 | 20 | 30 | 50 ]%, |
| Microwave frequency | 5.8GHz+/-75MHz |
| Microwave power | <0.2mW |
| Detection range |
Max.(O x H) for Rod Antenna : 8m x 4m Max.(O x H) for Flat Antenna : 12m x 6m where O is the detection angle; |
| Detection angle | 30~150 Degrees |
| Mounting height | rod antenna : 4m flat antenna : 6m |
| Operating temperature | -35 ~ +70 Degree Celsius |
| Safety standards | EN300440-1 | EN300440-2 | EN301489-1 | EN301489-3 |
| Certification | EMC, CE, R&TTE, SAA |
